IAI Corporation #RCS2-SA6C-A-30-6-300-T2-X10 Robo Cylinder Linear Actuator

Sale subject to additions AND deletions. 

Property listed in the auction sale catalog shall be offered for sale or sold by BTM Industrial, and any consignor of such property for whom BTM acts as agent. BTM Industrial strongly recommends to all bidders to thoroughly inspect all items before the auction. 

All Items are listed to the best of our ability, but are sold AS-IS with no warranty expressed or implied!

Under these Terms and Conditions, the term “Bidder” and “Purchaser” shall be used interchangeable and be one of the same. 

1. Bidder acknowledges that an auction site is a potentially dangerous place. Flammable, noxious, corrosive and pressurized substances may be present, heavy equipment may be in operation, and electric circuits may be live. Every person at the auction site before, during and after the auction sale, shall be deemed to be there at his/her own risk with notice of the condition of the premises, the activities on the premises, and conduct of third parties; and the bidder shall so advise his/her agents and employees. No person shall have any claim against BTM Industrial, its consignors, agents, employees, directors or principals for any injuries sustained or for damages to or loss of personal property, which may occur from any cause whatsoever. 

2. As used herein, the term “Bid Price” means the price at which a lot is knocked down to the Purchaser, and the term “Purchase Price” means the aggregate of (a) the Bid Price, (b) the Buyer’s Premium and other surcharges, if any, and (c) unless Purchaser is exempt by law from the payment thereof, any Federal, Provincial, State or local sales taxes (or compensating use tax of another State), and any other applicable taxes. Unless exemption from such taxes is established to the satisfaction of BTM Industrial, any Purchaser claiming an exemption will be required to pay the tax to BTM Industrial and seek a refund directly from the taxing authorities. 

3. A sale to the highest Bidder shall be complete upon the auctioneer’s call, with the highest Bidder purchasing the offered lot, in accordance with all the conditions set forth herein, including Purchaser (a) assuming full risk of loss and responsibility thereof, see Point 8 below, (b) immediately making a deposit of not less than twenty-five percent (25%) of the Purchase Price, and (c) paying to BTM the balance of the Purchase Price in full within forty- eight (48) hours after the auction sale for all lots purchased. No lot may be removed until the Purchase Price is paid in full for all lots purchased. To prevent miss-delivery and inconvenience in settlement of a purchase, no lot may be transferred prior to removal by the Purchaser. 

4. If the conditions herein or any other applicable condition(s) are not complied with, in addition to other remedies available by law to BTM Industrial and/or its consignors, including but without limitation, the right to hold the Purchaser liable for the Purchase Price, BTM may, at its option, either (a) cancel the sale in part or in full, retaining as liquidated damages all payments made by Purchaser or (b) resell the property, either publicly or privately, after three (3) days notice to the Purchaser and for the account and risk of the Purchaser, and in such event the Purchaser shall be liable to BTM for any deficiency if the resale is less than the Purchase Price, plus all costs, including warehousing, the pro-rate share of expenses of both sales including reasonable attorneys fees, BTMs’ commission, plus all other charges due here under and incidental damages suffered by 
BTM or its consignor. 

5. Only cash, wire transfer, bank draft or certified check will be accepted as payment of the Purchase Price. Personal or company checks may be accepted by BTM, at its sole option, on the condition that they must be accompanied by a letter from the Purchaser’s bank unconditionally guaranteeing payment of the Purchase Price in full of items purchased. 

6. BTM reserves the right to withdraw any property at any time before actual sale.      Sale of any property shall not be considered as COMPLETED untilthe property is in the hands of the high bidder.     If for any reason a consignor needs to withdraw an item that had been in auction and the high bidder has NOT taken possession, the high bidder would be entitled to return of their original high bid, any buyers premium and loading / Shipping & Handling fees paid. The high bidder agrees they would not be entitled to any other form of compensation.    In addition, BTM Industrial, its agents, subsidiaries and / or consignorretain the right to bid on any items in this sale, any bids / purchases made would being held subject to the same buyer's premium and other terms and conditions as other bidders as stated in this agreement.     BTM Industrial also reserves the right to reject a bid from any Bidder.    In the event of any dispute between bidders, or in the event of doubt on the part of BTM as to the validity of any bid, the auctioneer shall have the sole discretion either to determine the successful bidder or to re-offer and resell the lot in dispute. If any dispute arises after the sale, BTM's sales record shall be conclusive in all respects.

7. BTM Industrial reserves the right to reject a bid from any Bidder. The highest Bidder as acknowledged by the auctioneer shall be the Purchaser. In the event of any dispute between bidders, or in the event of doubt on the part of BTM as to the validity of any bid, the auctioneer shall have the sole discretion either to determine the successful bidder or to re-offer and resell the lot in dispute. If any dispute arises after the sale, BTM`s sales record shall be conclusive in all respects. 

8. Purchase of any lot is at the Purchaser’s risk with risk of loss immediately passing to Purchaser upon the auctioneer’s call. Neither BTM, nor its consignors, have any liability of any nature whatsoever to Purchaser if the lot is not delivered to Purchaser due to fire, theft, damage, or any other cause. 

9. All lots purchased shall be removed in their entirety from the site at Purchaser’s sole cost and responsibility and by the date as specified in the auction catalog or as posted or announced at the sale. No items may be removed before termination of the sale. Removal shall be at the sole risk and liability of the Purchaser or Purchaser’s agent, and only after Purchaser has provided BTM satisfactory proof of insurance by Certificate of Insurance or otherwise. Purchaser shall fully indemnify BTM and its consignors for any loss arising from damage to any person or property caused to any extent by Purchaser’s removal of the lots purchased. 

10. Purchaser is solely responsible to secure all safety equipment as may be necessary and prudent to meet all government safety standards in using, operating or removing lots purchased.

 
11. If BTM or its consignor is unable to deliver any lot or any necessary documentation required in respect of any lot, their sole and exclusive liability shall be the return of any monies paid on such lot. 

12. Absolutely no warranty or representation, written or oral, is given with any lot. All statements contained in BTM’s catalog, website, marketing material or by the auctioneers, or in any bill of sale, invoice or elsewhere as to description, size, quantity, quality, capacity, model, serial number, measurements or condition, are approximated statements and shall not be deemed to be representations or warranties, oral or written, with respect to any lot. No sale is invalid or made void by reason of any flaw in a lot or by reason of a lot being incorrectly described, and BTM will not be liable and no compensation will be paid for any such fault or error of description. 

13. All property is sold “AS IS, WHERE IS”. Neither BTM nor the consignor makes any representation or warranty, oral or written expressed or implied, as to the merchant-ability, fitness for a particular purpose, condition of the property, correctness of the description, condition, capacity, age or any other details used to describe the property. Absolutely NO RETURN of sold goods, NO REFUNDS, and NO EXCHANGES will be permitted. 

14. Owners of the machinery have the right to add or remove lots as needed. If item has been paid for, a full refund will be given if lot is deemed not available anymore.